Signode AM Series Operation, Parts And Safety Manual page 6

OPERATING INSTRUCTIONS, Continued
3. While standing to one side of the strapping line,
pull the tensioning handle back then push it
forward. Repeat this action until the desired
tension has been drawn.
Do not push the handle too far forward, as a
loss of tension could occur. Note the dotted
line in the illustration to the right.
4. Complete the sealing and cut off action by
pulling the sealing handle to its full rear
position.
5. To remove the tool from the tensioned strap,
return both the tensioning and sealing handles
to their forward positions. Place your left hand
on the tensioning handle and your right hand on
the knob. Swing the rear of the tool to your left
until it is free of the strap. Inspect the joint to
make sure the tool has properly notched the
seal.
6