Ethernet Setting - ProLights Halupix User Manual

• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically
FixHours
Show the fixture working hours.
• Press the button MENU so many times until shows [INFORMATION]. Press the button ENTER to confirm
• Using the button UP/DOWN to select [FIXTURE HOURS], then press the button ENTER to confirm
• Then the display will show the working hours.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically
Version
Show the fixture firmware version.
• Press the button MENU so many times until shows [INFORMATION]. Press the button ENTER to confirm
• Select through the button UP/DOWN the [VERSION] menu voice.
• The display will show the firmware data.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.
IP Address
Show the IP Address of fixture.
• Press the button MENU so many times until shows [INFORMATION]. Press the button ENTER to confirm
• Select through the button UP/DOWN the [IP ADDRESS] menu voice.
• The display will show the IP address.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.
Device ID
Show the device ID of fixture.
• Press the button MENU so many times until shows [INFORMATION]. Press the button ENTER to confirm
• Select through the button UP/DOWN the [DEVICE ID] menu voice.
• The display will show the device ID.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.
Temperature
In [TEMPERATURE] you can view on the display the temperature of the device.

3.16 ETHERNET SETTING

It is possible to change the Ethernet setting in the following way:
• Press the button MENU so many times until shows [ETHERNET SETTING]. Press the button ENTER to
confirm.
• Press the button UP/DOWN to select [PROTOCOL, IP MODE, NET, SUBNET, UNIVERSE, STATIC CHANNEL, ARTNET
TO DMX].
• Press the ENTER button to proceed.
• Set the value of parameter, through the button UP/DOWN and press the button ENTER to confirm.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.
HALUPIX
19