Fermax CITY FINGERPRINT READER User& Installer's Manual page 24

FINGERPRINT FINGERPRINT FINGERPRINT FINGERPRINT FINGERPRINT FINGERPRINT FINGERPRINT FINGERPRINT
FINGERPRINT FINGERPRINT
2. d2.2 is shown. Enter the fingerprint again to confirm.
d 2. 2
1 beep
1b. d2.1 is shown, cancel if we wish to register an unblock card. The LEDs of the reader start to flash, present
the card that we wish to register in the system as the unblock card.
d 2. 1
0 y
1 beep
* Activate the Unblock function
This function is used when you want the door to remain continuously open. It is activated by
sliding the trade fingerprint/presenting the unblock card through the reader's sensor when
in standby mode. The function remains enabled until the trade fingerprint is entered/the
unblock card is presented again, and then it will be disabled.
The green LED on the reader will remain continuously on when this mode is enabled.
Standby Mode
1. Enter the unblock fingerprint or
2. Remains activated until the unblock card/fingerprint is entered again.
function enabled
e) Add a security finger/card
Add a user (security fingerprint or security card) which will allow the reader mode to be
changed. Standard or security modes available. See the chapter on: see Operating
Modes chapter.
S e c
1 beep
1. d2.1 is shown, confirm if we wish to register a security fingerprint. Enter the new user fingerprint you
wish to register as a security fingerprint on the system.
d 2. 1
2. d2.2 is shown. Enter the fingerprint again to confirm.
d 2. 2
1 beep
Pag 24
0 y
x
1 2 3
4 5 6
7 8 9 +
1 beep
x -
0
Cancel for unblock
REMOTE UNIT
FOR ACCES CONTROL
card
U n b L
present the unblock card
1 2 3
4 5 6
7 8 9 +
x -
0
REMOTE UNIT
FOR ACCES CONTROL
1 2 3
4 5 6
1 beep
7 8 9 +
x -
0
Confirm for security
REMOTE UNIT
FOR ACCES CONTROL
fingerprint.
0 y
U n b L
1 beep
1 beep
function disabled
d 2. 1
1 beep
function enabled
0 y
S e c
1 beep
1 beep