Fermax CITY FINGERPRINT READER User& Installer's Manual page 23

FINGERPRINT FINGERPRINT FINGERPRINT FINGERPRINT FINGERPRINT FINGERPRINT
FINGERPRINT FINGERPRINT FINGERPRINT FINGERPRINT
1b. d2.1 is shown, cancel if we wish to register a trade card. The LEDs of the reader start to flash, present
the card that we wish to register in the system as the trade card.
d 2. 1
0 y
1 beep
* Activate the Trades function
This function is used when you want to offer free access to an area to be controlled. It is
activated by sliding the trade fingerprint/presenting the trade card through the reader's
sensor when in standby mode . The function remains enabled until the trade fingerprint
is entered/the trade card is presented again, and then it will be disabled.
In this mode, any fingerprint/card entered will activate the lock-release. The green LED
on the reader will flash when this mode is enabled.
Standby Mode
1. Enter the trade fingerprint
or present the trade card
t r d
1 beeeep
function enabled
2. Enter the trade fingerprint or present the trade card
function enabled
d) Add an unblock fingerprint/card
The Unblock option is a special function. In this mode the lock-release relay remains
continuously enabled. You can register an unblock fingerprint or register an unblock
card.
To add an unblock card/fingerprint access the option: UnbL.
U n b L
1 beep
1. d2.1 is shown, confirm if we wish to register a unblock fingerprint. Enter the new user fingerprint you
wish to register as an unblock fingerprint on the system.
d 2. 1
FOR ACCES CONTROL
x
1 2 3
4 5 6
7 8 9 +
1 beep
x -
0
REMOTE UNIT
FOR ACCES CONTROL Cancel for trade card
t r d
function disabled
1 2 3
4 5 6
7 8 9 +
x -
0
REMOTE UNIT
FOR ACCES CONTROL
1 2 3
4 5 6
7 8 9 + 1 beep
x -
0
Confirm for unblock
REMOTE UNIT
fingerprint.
d 2. 1
1 beep
any
fingerprint
or card
0 y
1 beep
Pag 23