Ethernet Software Configuration - Advantech PPC-57 Series Manual

PG8019.EXE
The PPC-57 is set at the factory by using this program. Upon
receipt of the PPC-57, you should use RSET8019.EXE to config-
ure your system for the working environment. If by chance the
Ethernet EEPROM is corrupted, the PG8019.EXE program allows
you to configure the card.
8019AS.CFG
This file contains the configuration parameters that are used by
PG8019.EXE.
Users can configure Ethernet settings by using the PG8019.EXE
programming utility. Follow these steps:
1. Edit the 8019AS.CFG file by using any text editor (e.g.
Windows Notepad, or the MS-DOS Edit command). Modify
"IOBASE" and "IRQ" to the setting for your system. Exit after
you have finished modifying and saving the file.
2. Make sure that PG8019.EXE and 8019AS.CFG are under the
same directory. Execute the programming utility.
C:\PG8019 8019AS.CFG
3. Reboot your computer.

Ethernet software configuration

The PPC-57's on-board Ethernet interface supports all major
network operating systems. To configure the media type, view the
current configuration, or run diagnostics, follow these steps:
1. Turn on the power to the PPC-57. Ensure that the
RSET8019.EXE file is located on the working drive.
2. At the prompt, type RSET8019.EXE and press <Enter>. The
Ethernet configuration program will then be displayed.
Chapter 5 Software Configuration
59