Table of Contents
Advertisement
Hardware Preparation and Installation
1
Equipment Required
Overview of Startup Procedures
1-2
A typical CPIP5430 environment requires the following additional
equipment:
System enclosure, or available PICMG 2.16 slot in a system
VGA monitor, VGA PMC, and USB keyboard, or serial terminal
Operating system (may only require a kernel)
Optional disk drive
Optional CPIP5430-RTM1 Rear Transition Module
USB mouse, floppy drive and/or CD/DVD drive, or IDE CD/DVD
drive
Connecting cables
The following table lists the things you will need to do before you can use
this board and tells where to find the information you need to perform each
step. Be sure to read this entire chapter, including all Caution and Warning
notes, before you begin.
Table 1-1. Startup Overview
What you need to do...
Unpack the hardware.
Prepare the hardware for
insertion into a chassis.
Ensure memory mezzanines are
properly installed on the board
Refer to...
Unpacking Guidelines on page 1-3
Hardware Preparation on page 1-4
Memory Module Installation on page 1-9
Computer Group Literature Center Web Site
Advertisement
Table of Contents
