Table of Contents
Advertisement
Hardware Preparation and Installation
1
1-12
4. Carefully remove the CPIP5430 from its slot and lay it flat, with
connectors J1 through J5 facing you.
5. Remove the PMC key-bolts of the second PMC slot.
6. Bolt the carrier rails onto the sides of the 2.5" HDD. The flange on
each rail should be facing away from the drive.
7. Attach the 44-pin IDE cable to the drive.
8. Install the drive assembly onto the top side of the board and tighten the
four screws from the bottom side of the board to secure the drive
firmly (avoid overtightening).
9. Connect the 44-pin IDE cable to the J18 IDE connector on board.
4276 0404
Computer Group Literature Center Web Site
Advertisement
Table of Contents
