Motorola CPIP5430 Installation And Use Manual page 72

Functional Description
Table 4-1. CPIP5430 Features Summary (continued)
Feature
USB Interface
4
Watchdog Timer
On-board Ethernet
(PICMG 2.16
compliant)
On-board Ethernet
(Management Port)
System Management
Interface
OS Compatibility
4-2
Description
Supports one port (USB0 - type A connector) on front panel for
development, service, and setup operations only
Supports two ports (USB1 & USB2 - type A connector) on RTM
USB Specification Rev. 2.0 compliant
Over-current protection on each USB port
The 2-stage, watchdog timer is built into the 6300 ESB ICH,
it is programmable from 1 microsecond to 10 minutes.
Two Ethernet ports on rear I/O connector (RTM) are provided by one
Intel 82546EB dual-port Gigabit Ethernet controller
On 64-bit/66 MHz PCI bus
IEEE 802.3x compliant flow control support
EEE 802.3ab compliant 10/100/1000 Mbps auto-negotiation
One Ethernet port on front panel (COM1) provided by one Intel
82547EI Gigabit Ethernet controller
On Communication Streaming Architecture (CSA) bus
IEEE 802.3x compliant flow control support
IEEE 802.3ab compliant 10/100/1000 Mbps auto-negotiation
Front panel Ethernet port can be routed to the RTM
QLogic Zircon Peripheral Management Controller with 14KB internal
SRAM
Supports PICMG 2.9 secondary system managing bus and implements
IPMI functions as defined in the IPMI Specification v 1.0
Monitors onboard voltages, temperatures
Supports external 16-bit flash ROM up to 1MB (protected boot block
required)
Two-stage watchdog timer, externally programmable via IPMI
Red Hat Linux versions with 2.4.20 and newer kernels
Computer Group Literature Center Web Site