Table of Contents
Advertisement
Hardware Preparation and Installation
1
1-10
The CPIP5430 SBC supports up to two slots of 144-pin, DDR2100
registered ECC SO-DIMMs. The maximum memory capacity is 4GB. The
chipset supports 64MB, 128MB, 256MB, 512MB, 1GB, and 2GB memory
module sizes. The supported DRAM types are listed in the following table.
All standard 128-Mb, 256-Mb and 512-Mb technologies and addressing
are supported for x16 and x8 devices.
The DDR speed, type and size can be determined from the BIOS reading
the DIMM Serial Presence Detect (SPD) bits on the SMBus. The DDR
timing register, which provides the DDR speed control for the entire array,
must be programmed to use the parameters of the slowest installed DDRs.
The DDR interface supports 128Mb, 256Mb, and 512Mb technology,
which allows up to 1GB per double-sided SODIMM. The CPIP5430
supports up to 4GB of SDRAM memory with two 144-pin SO-DIMMs.
The memory configurations are summarized in the following table.
CPIP5430-
2231/4231
CPIP5430-
Model Number
2232/4232
Memory Sockets
2
Max. Memory
1GB
SODIMM Size
512MB
SODIMM
2
Quantity
PMC slots
2:1
IDE Hard Drives
0:1
The CPIP5430 has been tested with 128MB, 256MB, 512MB, 1GB, and
2GB registered, ECC SODIMM modules.
To install the memory module, follow these steps.
1. Remove the CPIP5430 from the chassis and place it on a static free
surface.
Note
The following illustration may not represent the exact board
you are using, it is meant for illustration purposes only.
CPIP5430-
2241/4241
CPIP5430-
2242/4242
2
2GB
1GB
2
2:1
0:1
Computer Group Literature Center Web Site
CPIP5430-
4251-4452
2
4GB
2GB
2
2:1
0:1
Advertisement
Table of Contents
