Component Identification - Graco GLC 2200 Instructions Manual

Component Identification

Keypad, Display, and Icons
NOTICE
To prevent damage to soft key buttons, do not press
the buttons with sharp objects such as pens, plastic
cards, or fingernails.
A
F
!
J
F . 1
IG
Pump ON LEDs (A, B, C)
APressure Control LED: In RUN MODE illuminates
indicating function mode that is currently running.
BCycle Control LED: In RUN MODE illuminates
indicating function mode that is currently running.
CTime Control LED: In RUN MODE illuminates
indicating function mode that is currently running.
Pump OFF LED (D)
•In RUN MODE this LED illuminates when in the
OFF or RESET portion of the RUN CYCLE.
3A2960F
B
C
Display (E)
•A blinking field on the display indicates the controller is
in SETUP MODE.
•In RUN MODE numbers on the display will not blink.
Alarm LED (F)
Illuminates when any alarm is detected. When an alarm
is active an error code displays and an audible alarm
also sounds.
D
RIGHT Direction Arrow / MANUAL RUN /
ENTER (G)
•In SETUP MODE, saves entry, moves cursor in dis-
play one field to the right or to the next setup
step.
E
•In RUN MODE activates the pump for one com-
plete ON cycle if actuated during the OFF por-
tion of the RUN cycle.
G
UP and DOWN Direction Arrows (H)
•Press and hold both the UP and DOWN Arrow keys
together for 3 seconds to enter SETUP MODE.
H
•In SETUP MODE increase or decrease number
values associated with the various RUN
MODES.
LEFT Direction Arrow / RESET (J)
•In SETUP MODE moves cursor in display one field
to the left.
•In RUN MODE, Pressing RESET starts a PUMP
OFF cycle.
•In ALARM MODE, Press once to clear buzzer;
Press and hold for 3 seconds to clear warning
and switch controller to OFF MODE.
Component Identification
3