Graco GLC 2200 Instructions Manual page 12

Setup
Programming ON Duration
•on:Pr, on:CY or on:ti appears on the display identify-
ing the function you are programming (see below).
•The illuminated LED below the related symbol on the
controller label also indicates the function.
NOTE: Selection on:Pr, on:CY or on:ti designates
the way the pump run time is controlled:
•on:Pr = Pressure Control, reach-
ing a specific pressure thresh-
old measured by an external
pressure switch
•on:CY = Cycle Control, complet-
ing a specific number of
cycles of an external
prox/cycle switch
•on:ti = Time Control, a specific
duration of time elapses
Pressure Control (on:Pr) ON Setup
1.Use the UP or DOWN ARROW
until on:Pr displays.
2.Press the ENTER button.
3.Pressure control is an ON / OFF
selection only. After you press the
ENTER button, the controller saves the Pressure
Control information and moves to setting Backup
Time, page 13.
12
Cycle Control (on:CY) ON Setup
1.Use the UP or DOWN ARROW until
on:CY displays.
2.Press the ENTER button.
The first number displayed after the
on:CY is entered, blinks, indicating the device is ready
to program the number of cycles.
NOTE: The cycle entry is a 2-digit number. A leading
zero (0) must be entered in the first field if the number of
cycles is fewer than 10.
3.Program the cycles by pressing the UP or DOWN
ARROW to move up or down through the numbers
0-9.
4.When the correct first digit is displayed, press the
ENTER button.
The cursor automatically moves to the second number
field and flashes.
Use the UP or DOWN ARROW to scroll through the
numerals 0-9 until the desired number appears in the
second cycle number field.
5.Press the ENTER button. After you press the ENTER
button, the controller saves the Cycle Control infor-
mation and moves to setting Backup Time, page 13.
Time Control (on:ti) ON Setup
1.Use the UP or DOWN ARROW to
cycle through until on:ti displays.
3A2960F