Advertisement
Quick Links
Repair
™
LineLazer
Kit for Replacing the Main
Control Board
Kit Number 25A493 Mainboard, Standard Series
Kit Number 25A494 Mainboard, HP Auto Series
Kit Number 25N788 Mainboard, Standard Series
Kit Number 25N789 Mainboard, HP Auto Series
For repair of LineLazers.
For professional use only.
Not for use in explosive atmospheres.
Important Safety Instructions
Read all warnings and instructions in LineLazer manuals.
Be familiar with the controls and the proper usage of the equipment.
25N848 Standard
Control Board
25N849 HP Auto
Control Board
3A4240B
EN
Advertisement
Related Manuals for Graco LineLazer 25A493
Summary of Contents for Graco LineLazer 25A493
- Page 1 Repair ™ LineLazer Kit for Replacing the Main 3A4240B Control Board Kit Number 25A493 Mainboard, Standard Series Kit Number 25A494 Mainboard, HP Auto Series Kit Number 25N788 Mainboard, Standard Series Kit Number 25N789 Mainboard, HP Auto Series For repair of LineLazers. For professional use only.
- Page 2 Disconnect Battery before Service Disconnect Battery before Service ES2000 3A4240...
-
Page 3: Installation
Removal Removal Installation 1. Remove bottom cover. 1. Install new main control board with 6 screws. 2. On HP Auto LineLazers, connect short red or orange, and black wires on charging board to main board. Loop wires as shown. Black ti28483a ES2000 HP Auto Series ti29198a... - Page 4 Installation 3. For LineLazer V 3900 or 5900, connect the other wires to the main board in the order shown. HP Auto Only 3A4240...
- Page 5 Installation ES2000 3A4240...
- Page 6 Installation 4. For LineLazer V 200HS, connect the other wires to the main board in the order shown. HP Auto Only 3A4240...
- Page 7 Installation 200DC/200MMA 3A4240...
- Page 8 Installation 5. Bundle and cable-tie the two gray wires on the right 8. Install bottom cover with 4 screws (do not pinch side of the main board as shown. wires). 6. On HP Auto units only, do not cable-tie the white 9.
- Page 9 Installation 12. Select 3900, 5900, 200HS, 200HS2P, or ES2000 to 14. With prime valve still open (no pressure), turn match your LineLazer (200DC and 200MMA use engine or striper OFF, then start engine or turn 200HS2P). striper ON to complete pressure transducer calibra- tion.
- Page 10 This manual contains English. MM 3A4240 Graco Headquarters: Minneapolis International Offices: Belgium, China, Japan, Korea GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA Copyright 2016, Graco Inc. All Graco manufacturing locations are registered to ISO 9001. www.graco.com...