Graco GLC 2200 Instructions Manual page 11

Setup
Entering SETUP MODE
1.Press both the UP and DOWN ARROW buttons
together for three seconds.
NOTE:
•If a button is not pushed for 1 minute, the controller
returns to the start of an OFF cycle.
•Setting changes are not stored unless programming is
completed and setup mode is exited normally by
pressing the ENTER button.
•A blinking dot below the HH, MM, SS, or ## indicates
the field currently being programmed.
PIN Code (Series E or later models only)
NOTE: If, after entering Setup Mode, four 0000's are
displayed, the unit has a PIN Code lock out enabled.
See Entering a PIN Code to Access Setup Mode for
instructions on entering a value.
Entering a PIN Code to Access Setup Mode
The controller does not require a user to provide a PIN
code to access the programming features of the unit.
However, some users may want to protect the program
settings and therefore, an option for adding PIN Code
authorization is available. The instructions for setting a
PIN Code are provided in the Advanced Programming
section of this manual. See page 19.
3A2960F
To enter the PIN Code:
1.Press both the UP and DOWN ARROW
buttons for 3 seconds.
2.Four zeros appear on
the display indicating
the system requires a
PIN Code entry to
access the SETUP
MODE.
3.The cursor is automatically positioned to
enter the first character of the PIN Code.
Use the UP and DOWN ARROW buttons
to move up and down through the num-
bers 0-9 until the first number in the PIN
code is displayed in the field.
4.Press the ENTER (right arrow) button to
set the number. The cursor automati-
cally moves to the next number field.
5.Repeat steps 3 and 4 for each PIN Code prompt field.
If the PIN Code you entered is correct, the unit will enter
setup mode.
6.Press the ENTER (right arrow) button to
set the number. The cursor automati-
cally moves to the next number field.
NOTE: A blinking field on the display indicates the is
in SETUP MODE. In RUN MODE numbers on the
display will not blink.
Setup
11