Table of Contents
Advertisement
E
E-4
be<num>: bqeallocthings: Not enough system memory
The driver cannot allocate sufficient memory for resources. These messages
occur when attempting to load the driver. You will be unable to load the driver
until sufficient memory becomes free. Terminating unnecessary processes or
unloading unused drivers are ways to free memory.
be<num>: bqeallocthings: berpending and qerpending are too large
The values for the berpending and qerpending combined are too large. This
should not happen unless you try to adjust these values. Reduce the values
until the driver will load.
be<num>: bqeread: mbuf alloc failed
There is a resource shortage in the operating system most likely due to the
system being too busy. As a result, a received packet has been dropped. This
condition should be transitory.
be<num>: beinit failed:
The driver could not allocate enough receive buffers for the interface. The
interface will not be usable.
be<num>: beinit: unit not on the list
and
be<num>: bestart: unit not on the list
An invalid device unit number was passed into the specified routine. This
SunFastEthernet Adapter User Guide—November 1994
out of buffers
Advertisement
Table of Contents
