Table of Contents
Advertisement
5.1 Network Link Ups
5.1.1 10/100Mbps Link Up Using RJ45 Connector
Network Linkups/Speed Selection
The information presented in this chapter is applicable to both Solaris 1.x and
2.x software versions.
If your SunFastEthernet channel is connected to a 10 or 100Mbps network
through the RJ45 connector you will receive a Link Up message whenever you
boot the system or disconnect and then reconnect to the network.
For 10Mbps the message is:
# be<num>: Using Onboard Transceiver
10 Mbits/sec Link Up
For 100Mbps the message is:
# be<num>: Using Onboard Transceiver
100 Mbits/sec Link Up
5
5-1
Advertisement
Table of Contents
Need help?
Do you have a question about the SunFastEthernet Adapte and is the answer not in the manual?
Questions and answers