Table of Contents
Advertisement
2
2.2 Testing the SunFastEthernet Adapter Card Before Booting the System
2-2
Use the onboard transceiver RJ45 connector for Category 5, data grade
UTP wiring (100M maximum).
The external transceiver MII Interface connector can be used for
Category 5, data grade UTP or for other wiring types (dependent upon
the transceiver type). For example: Category 3 voice grade (UTP), fiber
optic, STP, etc.
5. Verify SunFastEthernet installation by testing the card as indicated in the
following section.
Note – To utilize the SunFastEthernet Adapter card, the system needs to
contain OpenBoot™ PROM (OBP) level 2.3 or later.
After the SunFastEthernet Adapter card is installed, and before booting the
system, verify installation by performing the following procedure:
1. Power on the system and when the banner appears press the L1-A key to
get to the ok prompt.
SunFastEthernet Adapter User Guide—November 1994
Advertisement
Table of Contents
Need help?
Do you have a question about the SunFastEthernet Adapte and is the answer not in the manual?
Questions and answers