Net-Install Servers; Table 4-3 Solaris 2.3 Hardware: 8/94 Cd - Sun Microsystems SunFastEthernet Adapte User Manual

4

4.3.1 Net-Install Servers

4-6
Table 4-3 Solaris 2.3 Hardware: 8/94 CD
Cluster
Entire Distribution plus OEM Support
Entire Distribution
Programmer
End User System Support
Core System Support
If SunFastEthernet hardware was not installed when the Solaris 2.3 Hardware:
8/94 software distribution was installed using one of the last four clusters,
then the driver is not automatically installed via suninstall, instead, the driver
must be installed using the pkgadd command. Refer to Section 4.2.3, "Adding
SUNWbmac Using pkgadd Command," on page 4-3".
Note – The Solaris CD cannot be used to do a net-install (read only), thus the
following section is applicable only when the Solaris CD image is archived to a
disk.
To allow net-install over the be interface the be minor-device- number must be
added to your particular architecture's name_to_major file. To determine the be
minor-device-number proceed as follows:
1. Determine the directory where the Solaris CD image is loaded.
For example, if the Solaris software is located within a directory named DIR,
then type the following:
# cd DIR/export/exec/kvm
2. Use the ls command to list the directory contents.
Different directories for supported architectures will be listed.
SunFastEthernet Adapter User Guide—November 1994
Size
298.80 MByte
298.1 MByte
220Mbyte
125.37 MByte
59.88 MByte