Maintenance - AGFA CR 30-X User Manual

Maintenance

Preventive Maintenance
Regular preventive maintenance needs to be done once a year or after 12000
cycles (whatever comes first). This maintenance can not be done by the user
but has to be done by an Agfa certified field service engineer. Not performing
the regular maintenance by appropriately certified people can have impact on
warranty commitments.
Cleaning and Disinfection
Refer to section
Cleaning the optical unit
The only maintenance action which you must perform is checking the image
quality. Refer to the User Manual of the NX
Cleaning the optic unit is required if stripes parallel to the image plate
movement can be seen in the image. When you recognize this type of artefact,
when using the digitizer, clean the optic unit using the cleaning brush.
2386G EN 20120110
"Cleaning and Disinfection" on page 23.
TM
Software.
CR 30-X/CR 30-X
M
25
Introduction