AGFA CR 30-X User Manual page 22

CR 30-X/CR 30-X
M
Safety Instructions for Laser Products
CLASS 1 LASER PRODUCT
APPAREIL A LASER DE CLASSE 1
LASERKLASSE 1
The digitizer is a Class 1 Laser Product. It uses one laser diode of a 80 mW
type, classification class IIIb, wavelength 640-670 nm. The laser beam's
deflection frequency is 120 1/s up to 170 1/s. The laser beam divergence is
12 mrad.
Under normal operating conditions - device with all covers - there can be no
laser radiation outside the digitizer.
The technical concept does not allow the user to remove the top cover. The
concept provides maximum reliability that no image plate jam can occur in
the post scan area.
However, the user is allowed to open the front cover, e.g. to solve cassette or
image plate jams at the front side. When opening the front panel, all motor
driven system movements will be stopped (including the laser).
22
Introduction
WARNING: User interventions other than those described in this
manual can be hazardous with regard to laser radiation.
CAUTION!
CLASS 3B LASER RADIATION:
WHEN OPEN AVOID DIRECT
EXPOSURE TO THE BEAM!
VORSICHT !
LASERSTRAHLUNG KLASSE 3B:
WENN ABDECKUNG GEÖFFNET
NICHT DEM STRAHL AUSSETZEN!
CUIDADO!
RAYO LASER CLASE 3B:
EVITAR LA EXPOSICIÓN AL HAZ
CUANDO LA TAPA ESTÁ ABIERTA.
ATTENTION!
FAISCEAU LASER CLASSE 3B:
QUAND CAPOT OUVERT ÉVITER
DE S´EXPOSER AU RAYÓN!
2386G EN 20120110