For The Installer - Nibe VPB Series User's And Installer's Manual

3 For the Installer

General
VPB/VPBS is a series water heater, which is suitable for
connection to an external heat source.
The water tank has internal copper, stainless steel or
enamel corrosion protection. The water heater is
equipped with a charge coil that heats the domestic
water, resulting in excellent properties for hot water
charging.
VPBS 300 can be docked to thermal solar panels.
The water heater is designed and manufactured for a
maximum cut-off pressure of 10 bar in the water heater
and 3 bar on the primary side. Maximum permitted
temperature is 85 °C.
VPBS 300 is equipped with a copper finned tube for
connection of up to 6 m² of thermal solar panels.
The insulation is polyurethane, which provides excellent
heat insulation. The outer shell of VPB/VPBS is powder-
coated, white steel.
VPB/VPBS is equipped with a submerged tube for the
sensors for external control and display of hot water
heating.
VPBS 300 can be supplemented with a third sensor for
solar control.
Transport
VPB/VPBS should be transported and stored vertically
in a dry place. The VPB/VPBS may, however, be carefully
laid on its back when being moved into a building.
VPB/VPBS
15 - 40 mm
30 - 50 mm
0 R
0
R
Assembly
The water heater is only designed for upright installation.
The water heater's installation area should always have
a temperature of at least 10 °C (frost-free).
Position VPB/VPBS on a firm base that can take the
weight, preferably on a concrete floor or foundation.
Use the product's adjustable feet to obtain a horizontal
and stable set-up.
20-55 mm 30 - 50 mm
Supplied components
VPB/VPBS ENAMEL
Potentiostat
Chapter 3 | For the Installer
H o t w a te r 5 1 °C H M flo w 4 9 (5 0 ) °C
+ 2 0 -2
1
R 0
H M flo w 4 9 (5 0 ) °C
H o t w a te r 5 1 °C
+ 2 0 -2
1 0
R
7