Raise3D Pro2 Manual page 17

3D PRINTER MANUAL- RAISE3D PRO2 SERIES
Re-install the thumb screws, rotating clockwise, to
lock the build plate into position.
Open the side door of the printer, and install the
spool holders into the mounting points. Open one of
the included spools of filament, and place it on the
holder.
NOTE: The direction of filament spool should be
placed to rotate in clockwise if at points B and D, and
should be oriented to rotate counterclockwise at
mount points A and C.
Locate the open end of the filament, and feed it
through the guide tube.
- 16-
www.raise3d.com