Ethernet Leds - Sierra Wireless AirLink RV55 Hardware User's Manual

Table 2-11: LED Behavior
LED Color / Pattern
Network Solid Green
Solid Amber
Flashing Green
Flashing Green (3
sec. on/1 sec. off)
Flashing Red
Flashing Red /
Amber
Activity Flashing Green
Flashing Red
Flashing Amber
ALL Green LED chase
Amber LED chase
Red LED chase
a. To configure LED Power Saving Mode, refer to the ALEOS Software Configuration User Guide (Services chapter).

Ethernet LEDs

The Ethernet connector has two LEDs that indicate speed and activity. When looking into
the connector:
•
•
Rev. 1 June 2019
Connected to an LTE network
Connected to a 3G or 2G network
Connecting to the network
Network Ready—WAN over Wi-Fi (router is in Wi-Fi client mode)
No network available
Network Operator Switching is enabled, but the router is unable to locate the
required firmware. For more information, refer to the ALEOS Software
Configuration User Guide (Admin chapter).
Traffic is being transmitted or received over the WAN interface.
Traffic is being transmitted or received over the serial port. This behavior only
appears if the RV55 router is configured to display it. For more information, refer
to the ALEOS Software Configuration Guide (Serial chapter).
Traffic is being transmitted or received over both the WAN interface and the
serial port. This behavior only appears if the RV55 router is configured to display
it. Refer to the ALEOS Software Configuration Guide (Serial chapter).
Radio module reconfiguration/firmware update or Network Operator Switching is
in progress.
ALEOS software update is in progress.
Recovery mode
Activity—The right LED is solid amber when a link is present and flashing amber
when there is activity.
Connection Speed—The left LED indicates the Ethernet connection speed:
· Solid Green—1000 Mbps
· Solid Amber—100 Mbps
· Off—10 Mbps
Description
37
Installation and Startup
LED Power Saving
a
Mode
Off
Off
41113042