Led Behavior - Sierra Wireless AirLink RV55 Hardware User's Manual

AirLink RV55 Hardware User Guide

LED Behavior

Figure 2-18: LED location
Table 2-11: LED Behavior
LED Color / Pattern
Power Off
Solid Green
Green with Amber
Flash
Solid Red
Flashing Green
Flashing Red
Flashing Amber
Signal Solid Green
Solid Amber
Flashing Amber
Flashing Red
Note: The quality of the signal strength is measured using the appropriate parameters for the radio technology in use.
Rev. 1 June 2019
Description
No power or input voltage
Power is present.
Power is present and the router has a GPS fix.
Standby mode
When you press the reset button, flashing green indicates when to release the
reset button to reboot the router.
When you press the reset button, flashing red indicates when to release the
reset button to reset the router to the factory default settings.
When you press the reset button for more than 20 seconds, flashing amber
indicates when to release the reset button to enter Recovery mode. (See
Recovery Mode on page 40.)
Good signal (equivalent to 4–5 bars)
Fair signal (equivalent to 2–3 bars)
Poor signal (equivalent to 1 bar)
If possible, Sierra Wireless recommends moving the router to a location with a
better signal.
Inadequate (equivalent to 0 bars)
Sierra Wireless recommends moving the router to a location with a better signal.
36
≥ 36 VDC or ≤ 7 VDC
LED Power Saving
a
Mode
Off
Off
41113042