Sample Power Consumption Scenarios - Sierra Wireless AirLink RV55 Hardware User's Manual

Sample Power Consumption Scenarios

Note: All power consumption figures are preliminary.
Table 1-2: Power Consumption Scenarios
Scenario Radio
Standby Mode —
Low Power — Idle
Serial Attached
Low Power — Idle
Ethernet Attached
Low Power — Idle
b
Wi-Fi Attached
Typical Attached
without Power and
Saving connected
Features (+20 dBm
LTE)
Maximum Attached
without Power and
Saving connected
Features (+23 dBm
LTE-A)
Peak without Attached
Power Saving and
c
Features connected
(+32 dBm
1 up/
1 down
GSM/
GPRS/
EDGE
bursts)
1.5 A @ 12 V (Averaged over 100 s)
Inrush Current
a. Power consumption was measured at 12 V.
b. Wi-Fi A and B set up as access points with nothing connected to them.
c. Peak without power saving is similar to Maximum without power saving, but measured as a maximum burst over a limited time.
Rev. 1 June 2019
Ethernet Serial
— — —
Disabled Enabled Disabled
10 BaseT Disabled Disabled
Full duplex
Disabled Disabled Disabled
100 BaseT Enabled Enabled
Full duplex Idle Idle
1000 Enabled Enabled
BaseT Full
duplex
(maximum
throughput)
1000 Enabled Enabled
BaseT Full
duplex
(maximum
throughput)
13
Introduction to the AirLink RV55
USB GNSS Processor
Power
Saving
Mode
— —
Disabled Enabled
Disabled Enabled
Disabled Enabled
Enabled Disabled
Active
antenna
Enabled Disabled
Active
antenna
Enabled Disabled
Active
antenna
LED
a
Power
Power
Saving
Mode
— 38 mW
(3.14 mA)
Enabled 834 mW
(68.8 mA)
Enabled 874 mW
(72.2 mA)
Enabled 1.295 W
(107 mA)
Disabled 3700 mW
(308.3 mA)
Disabled 5500 mW
(458.3 mA)
Disabled 8000 mW
(666.6 mA)
41113042