Adding The Cm 1243-5 (Dp Master) Module And A Dp Slave - Siemens SIMATIC S7-1200 Manual

Easy to communicate between devices
7.6 PROFIBUS
7.6.3

Adding the CM 1243-5 (DP master) module and a DP slave

Use the hardware catalog to add PROFIBUS modules to the CPU. These modules are
connected to the left side of the CPU. To insert a module into the hardware configuration,
select the module in the hardware catalog and either double-click or drag the module to the
highlighted slot.
Table 7- 7 Adding a PROFIBUS CM 1243-5 (DP master) module to the device configuration
Module Select the module
CM 1243-5
(DP
master)
Use the hardware catalog to add DP slaves as well. For example, to add an ET200 S DP
slave, in the Hardware Catalog, expand the following containers:
● Distributed I/O
● ET200 S
● Interface modules
● PROFIBUS
Next, select "6ES7 151-1BA02-0AB0" (IM151-1 HF) from the list of part numbers, and add
the ET200 S DP slave as shown in the figure below.
Table 7- 8 Adding an ET200 S DP slave to the device configuration
Insert the DP slave
142
Insert the module Result
Result
Manual, 11/2011, A5E02486774-04
Easy Book