Verifying The Network Connection; Verifying Operation By Running Sunvts Software - Sun Microsystems SPARC Enterprise M4000 Installation Manual

●
Connect the network to the domains using an Ethernet cable.
You can connect to either the Gigabit Ethernet (GbE) port on the I/O unit or on an
Ethernet card installed in the I/O unit.
4.3

Verifying the Network Connection

1. Check the LAN link lamp on the I/O Unit or PCI slot that is connected to the
network for activity.
2. Use a system on the network to navigate to one of the domains on the server.
Refer to the Solaris software documentation for information on accessing a server
over the network.
4.4 Verifying Operation by Running SunVTS
Software
Start the server from each domain, configure the server for the network, and run
SunVTS
operations and checking the device connection status.
Refer to the Solaris software documentation for information on starting the system
from each domain and configuring the domains for the network.
Refer to the SunVTS User's Guide for information on installing and use of the
SunVTS software.
4-2 SPARC Enterprise M4000/M5000 Servers Service Manual • November 2008
™
Software. The SunVTS software is a diagnostic tool for verifying hardware