Automatic Measurement - Dräger Alcotest 6510 Instructions For Use Manual

5.2

Automatic measurement

The sampling is activated automatically. There is no provision for
manual sampling.
5.2.1 Preparation
1. Insert new mouthpiece in the
holder (page 7).
2. Switch device on (page 8).
After 2 seconds "WAIT" is indi-
cated on the display.
After approx 8 seconds the
choice of person screen is dis-
played. Use the and
M
buttons to choose person and
the -button to confirm.
OK
Dräger Alcotest 6510
5.2.2
Alcotest 6510
1.
02123840.eps
WAIT
2.
02423840.eps
Persons
Driver
Specified
02523840.eps
After approximately 6 seconds
"READY" is displayed and a
short audible signal is given.
At the same time the current
test number is indicated. A
green light flashes.
The device is ready for
measurement.
Performing the measurement
Ask the test subject to blow
evenly into the mouthpiece
without interruption. A suffici-
ent flow is indicated by a conti-
nous tone and a green light.
Whilst the subject is blowing
the display shows: "Blow".
When the sampling is suc-
cessful the green light will
cease and the continuous tone
will stop. Instruct the subject to
stop blowing.
The display shows: "WAIT
Analyzing".
Performing the measurement
READY
Test No. 00140
02623840.eps
Blow
02723840.eps
WAIT
Analyzing
02823840.eps
9