Usage As A Cold Water High Pressure Cleaner; Usage As A Hot Water High Pressure Cleaner - Kranzle therm 890 Operating Manual

Electrical connection
- Check that the master switch (1) is off (position "0").
Hauptschalter
1
Main Switch
1A
- Switch off the ignition. Rocker switch (1A) to „0".
- Set the pressure control (4) valve to maximum
pressure (see on page 12) and close the detergent
valve (3).
- Open the gun and switch the master switch on.
The high pressure pump now presses the air out of the
lines, and after a short time the high pressure spray
forms and the operating pressure is reached.
(Open and close the gun repeatedly)
The machine is fitted with a Total-Stop-
System. If the gun is closed for longer
than approx. 20 seconds, the machine switches off automatically,
after 20 minutes the machine moves to safety switch off and you
must use the main switch to turn it back on.
The machine restarts automatically when the gun is operated,
provided that the master switch is on.

Usage as a cold water high pressure cleaner

- Leave the ignition "OFF". Rocker switch (1A) to „0".
- Start cleaning

Usage as a hot water high pressure cleaner

- Set the target temperature on the thermostat to min. 40 °C and than switch the
ignition "ON" (rocker switch).The oil burner starts to work. The water is heated up
and kept at the temperature you have set.
Steam level
To reach the steam level, i.e. over 90 ° C water temperature, open the right cover on
the housing (see page 13) and adjust the pressure or water quantity on the hand
wheel (4) downward and use the thermostat with rotary switch to select the
temperature up to a maximum of 150 °. In the case of machines with hose drums,
the high pressure hose must always be unwound completely.
14
Commissioning
Hauptschalter
Pr es sur e
100 100 150 150
200 200
50 50
b ar b ar
2 50 2 50
0 0
Wassertemperatur
Water temperatur e
70 80
60 90 Zu Auf
50 100 off o n
110
40
30 120
0
20 130
10 140
0 150
°C Hauptschalter
Cleaning liquid
Connect the power cable to a properly
installed electrical socket with earthing
and a 30 mA FI fault current safety
switch. The socket must have neutral 16A
fusing on the mains side.
3
2
4