FBII XL-20 Hookup And Installation Instructions page 51

XL-20 Hookup and Installation Instructions
QUESTION 21
CS CODES for OPEN/CLOSE and CS TEST
There are 4 locations (L1-L4) in this question:
Question 21, L1 - Opening Code
Question 21, L2 - Closing Code
L1 is the single-digit OPENING CODE. L2 is the single-digit CLOSING CODE. Entry of
AA into these two locations means that openings and closings are not desired. If a dialer
format other than standard is programmed, the second digit transmitted will be the user
number.
Question 21, L3 & L4 - CS Test Code
L3 - L4 is the CS Test code. The CS Test code will be transmitted at the interval selected
in question 07, location 3.
NOTE: Any digit entered will be transmitted unless CS Test is disabled; to disable CS
Test, see question 07, location 3.
QUESTION 22
CS CODES for BYPASS, RESTORE, TROUBLE and CANCEL
There are 4 locations (L1-L4) in this question:
Question 22, L1 - Bypass Code
L1 is the single-digit system BYPASS CODE that upon arming, will be reported to the
central station if a zone is bypassed. Entry of an "A" means that bypasses are not to be
transmitted. If a 2-digit dialing format has been selected, the Bypass code will be
followed by the programmed second digit of the Zone code.
Question 22, L2 - Restore Code
L2 is the single-digit system RESTORE CODE reported to the central station. Restores
will be reported for all Burglary or 24-hour zones by enabling this code (digits 0-9, B-F)
and enabling zone Restores in question 04, location 3. Entry of an "A" means that
Restores are not to be transmitted. If a 2-digit dialer format has been programmed, the
Restore code will be followed by the programmed second digit of the Zone code. NOTE:
Restore is not selectable by zone.
Question 22, L3 - Trouble Code
L3 is the single-digit system TROUBLE CODE reported to the central station. This code
will be reported on DAY TROUBLE and FIRE TROUBLE. If a 2-digit format has been
programmed, this code will be followed by the second digit of the respective Zone code.
Question 22, L4 - Cancel Code
L4 is the single-digit system CANCEL CODE reported to the central station. This code
will be sent if a user code is entered after a violation of a controlled zone. If the zone is
still violated, entry of a User code will transmit the Cancel code. If the zone is
programmed for restoral, then the Restore code will be transmitted when the loop status
has returned to normal. Entry of an "A" in this field indicates that Cancel codes are not
transmitted. In formats requiring 2 digits, the User number functions as the second digit.
QUESTION 23
CS CODES for KEYPAD FIRE and KEYPAD AUXILIARY
There are 4 locations (L1-L4) in this question:
9–18
DEFAULT = AAAA
Default = A
Default = A
Default = AA
DEFAULT = AAFA
Default = A
Default = A
Default = F
Default = A
DEFAULT = AAAA