FBII XL-2 Silver Quick Reference
  1. Manuals
  2. Brands
  3. FBII Manuals
  4. Security System
  5. XL-2
  6. Quick reference
FBII XL-2 Silver Quick Reference

FBII XL-2 Silver Quick Reference

Hide thumbs Also See for XL-2 Silver:
Table of Contents

Advertisement

Quick Links

See also: Owner's Manual
N9512 Rev.A 8/95

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XL-2 Silver and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for FBII XL-2 Silver

Summary of Contents for FBII XL-2 Silver

  • Page 1 N9512 Rev.A 8/95...
  • Page 2 Quick Reference TURN SYSTEM ON Check to make sure the system is READY - Green ready light is lit Enter your four digit user code The On/Off (Arm) light will light Exit through a door designated by your installer as an exitientry door. TURN SYSTEM OFF Enter through a door designated by your installer as an exiffenty...
  • Page 3 Introduction Congratulations on your decision to protect your home or business wiih the XL-2S security system. You have chosen a reliable, state of the afl se:urity system that is remarkably easy to operate. Your system hae been professionally installed by your local Security Company who can explain the specifics of your system.

  • Page 4: System Reference

    SYSTEM REFERENCE ZONE PROTECTED AREA Door Exit time Entry time Door Entry time ASSIGNED USER ID (MASTER USER .) Only Turns System On-Yesn If No Ambush/Duress Code -Yesn If No “Master User can Add, Change, or Erase other user codes. The following SEND HELP ALERTS are programmed into my system.

  • Page 5: Turn The System On And Leave

    TU~ING SYSTEM ON You can turn the Burglar portion of your security system on and off. Before you turn the system on it must be ready, If you have a protected door c)pen, or someone is moving by a motion detector the system will not show ready syetem is ready if the ready light ie on or if the display shows:...

  • Page 6: Turn System On And Stay Inside

    zone off, Example: you wish to keep the window open for ventilation. Zones whenthe systemison.See that are bypassed are not protected Bypass for the correct procedure. TURN SYSTEM ON AND STAY INSIDE To turn the perimeter potion of your burglar alarm on and move around freely inside is the STAY mode.

  • Page 7: Turn The System Off

    long beep and the zone or zones bypassed will slowly blink or the display shows: NOTE: Temporary users (i.e. baby sittars, housekeepers, etc.) should not be shown the Bypass procedure. UNBYPASS Unbypasa returns a bypassed zone to normal operation. Unbypass is a repeat of the bypass function, After unbypassing the zone display will show the state of the zones.

  • Page 8: Add Or Change A User Code

    After you have turned the system off with your user code the message on display keypads will show To clear the display of the alarm or trouble conditions and silence the audible alert: again. Enter your four digit user code USER CODES ADD OR CHANGE A USER CODE Users can be entered or modified directly through the keypad.
  • Page 9 Duress Your system can be programmed to send an emergency signal to the Central Station if you are forced to enter the premises. If you choose to include this feature, User Code number 6 is dedicated to this function and must only be used under a duress circumstance.
  • Page 10 i@de the ~miti. COVER {OPEM...
  • Page 11 INSTWWTION WYOLJT Eady warning fire detection is best achieved by the installation of fire detection equipment in the location as follows .— .w!- ““~”~ lAlff —- — In homes Mm more than one sleeping srea a smke detector should be provided to protect each area.

  • Page 12: Limitations Of This Alarm System

    SYSTEM LIMITATIONS LIMITATIONS OF THIS ALARM SYSTEM While this system, is an advanced design secuflty system, it does not offer guaranteed protetion againti burglay, fire, or other emergency. Any alarm system, whether mmmercial or residential, is su~ect to compromise or failure to wam fora vatiefy of reasons. For example B Intruders may gain access through unprotected openings or have the technical =ptistiation...
  • Page 13 Q However, even if the system responds to the emergency as intended occupants may have insufficient time to protect themselves from the emergency situation. In the case of a monitored alarm system, authorities may not respond appropriately. Even fho”gh @ ~s equipment, Ike other electrical devices, is subject to Component failure.
  • Page 14 GLOSS~Y AC INDICATOR. Small green fight betieen the center buttons on the keypad, When ht, the system is running on electtici~ when not It, the system is running on the backup batie~. ALARM. Sound from keypad or other hotisiren indicates a burglar alarm, fire alarm or other condition you should be aletied to.
  • Page 15 ON-STAY A system setting that turns on the petimeter protection of the building but allows movement throughout the inside, PANIC BU~ON: A push button wtich allows you to signal the Central Station that you need immediate assistance. Your system has programmable Keypad Send Help A18tis wMch can also sewe as Panic buttons.
  • Page 16 FEDEW COMM~ICATIONS COMMISSION (FCC) STATEMENT equipment has been tested to FCC requiremen~ and has been found accepbble for use. The FCC requires the following shtement for your information This equipment generates and uses radio frequency energy md if not installed and used propedy, that is, in stfiti awordance with me mantiacture<s instructions, may cause...
  • Page 17 fire Burgla~ Instruments, Inc,. a subsidiay of PiWay Coporatio”, a“d Wmay Corporation, its dvisions, subsidiaries and a~tiates ~Selter”), 149 Eileen Way, Syosset, New York 11791, warrants its secufity equipment (the ‘produc~) to be free from defects in matetial and workmanship for five years from date of original purchase, under normal use and sewice. Seller>s obbgation is Imited to repaiting or replacing, at iw option: free of charge for pans, labor, or transposition, any product proved to be defective in materials orworkma”ship under normal use and sewice, Seller shall have no obligation under this warranty or othewise if the...

  • Page 18: System Test

    SYSTEM TEST It is recommendedthat you test your system once a week using the followingprocedure: NOTE: If your system is monitored, contact your Central Station before you perform this test. 1. Turn your Security System on. 2. Wait until your exit time is over and them activate the system by opening a protectsd zone.

Table of Contents