FBII XL-20 Hookup And Installation Instructions page 50

Hardwired/wireless system
Hide thumbs Also See for XL-20:
Table of Contents

Advertisement

QUESTION 15
ZONE 5 TYPE & CS CODE
Question 15, L1 & L2 - Zone 5 Type
Question 15, L3 & L4 - CS Code for Zone 5
Zone 5 = Instant (Perimeter) w/CS Reporting code = 35
QUESTION 16
ZONE 6 TYPE & CS CODE
Question 16, L1 & L2 - Zone 6 Type
Question 16, L3 & L4 - CS Code for Zone 6
Zone 6 = Instant (Perimeter) w/CS Reporting code = 36
QUESTION 17
ZONE 7 TYPE & CS CODE
Question 17, L1 & L2 - Zone 7 Type
Question 17, L3 & L4 - CS Code for Zone 7
Zone 7 = Instant (Perimeter) w/CS Reporting code = 37
QUESTION 18
ZONE 8 TYPE & CS CODE
Question 18, L1 & L2 - Zone 8 Type
Question 18, L3 & L4 - CS Code for Zone 8
Zone 8 = Instant (Perimeter) w/CS Reporting code = 38
QUESTION 19
CS CODES for AMBUSH and AC LOSS
There are 4 locations (L1-L4) in this question as follows:
Question 19, L1 & L2 - Ambush Code
If an Ambush code is defined, User no. 6 is the Ambush code. The same rules apply here
regarding dialer format. If transmission is not desired, program AA in locations L1 & L2.
NOTE: AMBUSH transmissions are immediate and not abortable.
Question 19, L3 & L4 - AC Loss Code
The same rules apply here regarding dialer format. If transmission is not desired,
program AA in locations L3 & L4. NOTE: AC LOSS is reported 15 minutes after
detection.
QUESTION 20
CS CODES for PANIC and LOW BATTERY
There are 4 locations (L1-L4) in this question:
Question 20, L1 & L2 - Panic Code
The same rules for programming regarding dialer format apply here. If transmissions are
not desired, program AA in locations 1 & 2. NOTE: PANIC transmissions are immediate
and not abortable.
Question 20, L3 & L4 - Low Battery Code
The same rules for programming regarding dialer format apply here. If transmissions are
not desired, program AA in locations 3 & 4. LOW-BATTERY transmissions will be
reported 4 minutes after detection. LOW-BATTERY RESTORE CODE will be reported
within 4 minutes after detection of GOOD BATTERY condition.
Section 9 - System Programming
DEFAULT = 1035
Default = 10
Default = 35
DEFAULT = 1036
Default = 10
Default = 36
DEFAULT = 1037
Default = 10
Default = 37
DEFAULT = 1038
Default = 10
Default = 38
DEFAULT = AAAA
Default = AA
Default = AA
DEFAULT = 22AA
Default = 22
Default = AA
9–17

Advertisement

Table of Contents
loading

Table of Contents