Maintenance; Troubleshooting Guide - Kinetec Spectra User Manual

Maintenance

After 2,000 hours of operation, or once a year, the device Kinetec Spectra™ requires lubrication and
maintenance operations (lubrication of the joints, pointer stops and ball screws). If the message SERVICE
TIME Mx is displayed when the system is switched on, this indicates that maintenance is required.
Despite this indication, you can continue to use your machine by pressing [START], but you should
contact your nearest Kinetec
possible.
An after-sales service inspection sheet and the technical catalogue are available on request from your
Kinetec distributor.
®
WARNING: Before using this machine, always check that the electrical socket is in good condition
and is suitable for the splint power supply cord. Only use the original cable supplied with
the machine. Check that the cables remain free around the device so that they do not
get damaged.
WARNING: Before using this machine, always check that the machine is not damaged, in particular
the protective housings.
When the machine is no longer in working condition, please return it to us, together with its accessories, for
destruction.
Change the battery if there is no stored date (see the Technical Catalogue).
A motor running time counter is available by simultaneously pressing keys
the displays shows RESET TIME 215H (this is an example).
This counter can be reset by pressing the key

Troubleshooting guide

A spare parts list and technical catalogue are available on request from your Kinetec
If, after connecting the power supply cable to the power supply and switching on the machine:
• The display does not indicate any information:
- Check that the electrical socket is live using another device or
voltmeter.
- Replace the fuse(s) (25) of the connector with fuses of the same
type and calibre: 2 fuses T 750 mA 250V (6.3 x 32) (Kinetec
4610007434).
- Check that the hand control is connected properly.
- If the display still does not indicate any information, contact your
nearest Kinetec
• Your machine does not work and the display indicates 50 STOP 25 115,
Press [START] again.
If your machine still does not work, contact your nearest Kinetec
• Your machine does not work and the display indicates:
SERVICE D1: angle measurement function failure,
or SERVICE D2: no movement,
or SERVICE D3: abnormal consumption,
or PUSH STOP/START: power failure or disconnected motor,
or SERVICE D7:
contact your nearest Kinetec
then on
Centura™;
See the Kinetec Data Capture™ software user manual for more information.
• The USB is connected and the logo "usb" does not appear in the top right of the display:
Contact your nearest specialist Kinetec
Kinetec Spectra™
technician to have the maintenance operations carried out as soon as
®
technician.
®
the USB key was disconnected while in use;
technician if the same message is displayed after switching the device off,
®
or SERVICE D8: the USB key used has not been programmed for use on Kinetec
®
.
order:
®
.
EN
and
distributor.
®
25
technician.
®
;
15/20