Tool Pressure Adjustment - Roland CAMM-1 PRO CM-500 Service Notes

4 Adjustment

4-6 TOOL PRESSURE ADJUSTMENT

Make sure to adjust TOOL HEIGHT before this adjustment.
1
Put the WHITE DUMMY PEN (ST-006) on the TOOL
CARRIAGE.
4
Put the PINCH ROLLERs DOWN at both left and right ends
2
of the GRIT ROLLER.
The MIDDLE PINCH ROLLER should be UP.
Turn off the power and move the TOOL CARRIAGE to the
3
positions where the TOOL HEIGHT was adjusted.
Remove the FRONT APRON and set the VR1 and VR2 on
4
the MAIN BOARD at the center.
34
ST-006
WHITE
DUMMY PEN
PINCH ROLLER
MIDLE PINCH ROLLER
GRIT ROLLER
MAIN BOARD
VR2
PINCH ROLLER
VR1