Roland CAMM-1 PRO CM-500 Service Notes page 23

Fix the PINCH ROLL SENSOR.
8
It is necessary to prepare a soldering iron or pin-
disconnector to fix PINCH ROLL SENSOR.
Fix the TOOL CARRIAGE to the GUIDE RAIL.
9
Connect the PINCH ROLL SENSOR WIRE, SOLENOID
10
WIRE and CARRIAGE CABLE to the CARRIAGE
BOARD.
Then, fix it to the CARRIAGE BOARD STAY.
Carry out the following adjustments.
11
1. TOOL HEIGHT ADJUSTMENT
2. TOOL PRESSURE ADJUSTMENT
3. SEPARATING KNIFE ADJUSTMENT
PINCH ROLL SENSOR
TOOL
CARRIAGE
PINCH ROLL
SENSOR WIRE
SOLENOID
WIRE
3 Replacement of Main Parts
3
CARRIAGE CABLE
CARRIAGE
BOARD
19