4 Adjustment
Turn on the power.
5
Select "ROLL" with [
[ENTER] key. Then, press the [SETUP] key.
4
Select "ORIGIN SET" by pressing the [MENU] key 3 times.
6
Loosen the 2 screws shown in the figure.
7
Adjust the 2 screws shown in the figure so that the clearance
8
between the pen tip and the BED would be 2.4—3.0 mm at 5
positions (3 positions for CM-300) by moving the TOOL
CARRIAGE with [
32
] and [
] keys and press the
] and [
] keys.
[ENTER]
[SETUP]
Press the [MENU]
key 3 times.
SCREWS
SCREWS
SCREWS
TOOL CARRIAGE