Roland CAMM-1 PRO CM-500 Service Notes page 31

SYSTEM INFORMATION
Turn on the powr while
pressing [ ] key.
LIMITED INITIALIZE
Data which has been set by the
user inside the EEROM will be
initialized. Turn on the power
while pressing the [ENTER] key.
User initialize
NO YES
ENTER
User parameter
initializing..
Select factor
Knock Position
CAMM-1 PRO SERIES SYSTEM REPORT
MODEL : 0500
ROM VER : A120
BOOT VER : 110
DIPSW : 00000001
LANDINGWAIT: OFF
-- FACTORY PARAMETER ---
FACT CALIB.: CARR.=0.00% GRIT = 0.00%
LANDINGADJ.: CUT AT 0 BR 0 PEN AT 0 BR 0
KNIFE ADJ. : 0
LANGUAGE : ENGLISH
-- USER PARAMETER ---
CURRENT PEN: 1
TOOL SPEC : No VS FS OFST UPVS QUALITY
: 1 85 30 - - -
: 2 - - - - -
: 3 - - - - -
: 4 - - - - -
: 5 - - - - -
: 6 - - - - -
: 7 - - - - -
: 8 - - - - -
ROTATE : ON SMOOTHING : ON
DIPS UNIT : MILLI AREA UNIT : METER
CALIB CARR.: 0.00% CALIB GRIT : 0.00%
AREA LEN : 1.0 m PREFEED : ON
I/O : AUTO PROTOCOL : 9600
HANDSHAKE : HARDWIRE COMMAND : AUTO
PEN CHANGE : OFF VS CMD : OFF
FS CMD : OFF OVER CUT : OFF
SHEETCUT : CMD OFF. VS 50.MARGIN 5 . PASSES 1
TESTCUT PAT: TYPE1
-- END ---
ALL INITIALIZE
All data inside EEROM, including
Service Mode settings, will be
initialized. Turn on the power
while pressing [ ], [ ] and
[ENTER] keys.
EEROM all init.
NO YES
ENTER
EEROM all init.
Initializing..
Knock
Knife adjust
0mm -> +1mm
Position
Knife-Cutter adj
< 0.000mm >
This is for adjusting AUTO CUTTER ADJUSTMENT.
LANGUAGE SELECTION
Turn on the powr while
pressing [ MENU] key.
ENGLISH JAPANESSE
GERMAN
SPANISH
Press [ENTER] key to
save settings.
SERIAL INTERFACE CHECK
Turn on the power while
Connection
2 (TxD) 3 (RxD)
4 (RTS) 6 (DSR)
5 (CTS) 20 (DTR)
14 (STxD) 16 (SRxD)
4 Adjustment
Knife test
Hit/Away->ENTER
FRENCH
ITALIAN
pressing the [ ] key.
RS232C check NG!
Error bit= 1111
STxD-SRxD error
TxD-RxD error
DTR-CTS error
RTS-DSR error
27
4