Required Equipment - ESAB MT-400EHD Instructions For Use Manual

* Basic torches do not include liners, contact tips/tubes, or nozzles. Mix and match the accessories listed in Fig. 1.4 and
Tables 1.4.1, 1.4.2, and 1.4.3 to customize a torch for your welding application.
Basic Assy./Length
MT-200
MT-400
1.3 REQUIRED EQUIPMENT (See Fig. 1.3)
1.3.1 Wire Feeder Connector Assembly - P/N
2075378
Provides quick connect and disconnect of the
MT-200 or MT-400 to a MIG-35, or Digimig Wire
Figure 1.3 - Connecting MT-200 or MT-400 to a Mig-35 or Digimig Wire Feeder
Wire
Wire Size
Type In.
Hard 0.023
“H” 0.030
0.035
0.045
0.052
1/16
Cored 0.035
"C" 0.045
0.052
1/16
5/64
3/32
Soft 0.035
"S" 3/64
n Also requires Guide Bushing, P/N 17997 (see Fig. 1.3).
(a) Includes replaceable sleeve (995651).
(b) Includes replaceable sleeve (995692).
(c) Requires outlet guide insert (993902 - yellow for 0.035-in.; 05N57 - red for 3/64-in.)
TABLE 1.2 Basic Torch Assemblies Available (see Fig. 5.1)*
10-ft. (3.0m) 12-ft. (3.6m)
998888
999469
OUTLET GUIDE - 999745
INCLUDES INSERT - 999746
(CUT TO LENGTH)
Table 1.3 - Outlet Guide to Feed Roll
Wire Outlet Guide
MIG-35
Digimig
999745n
993860(a)
993860(a)
39N15(b)
39N15(b)
39N15(b)
9933860(a)
39N15(b)
39N15(b)
39N15(b)
62N17(c)
62N17(c)
29N13(d)
29N13(d)
15-ft. (4.5m)
948921 998887
948922 999470
Feeder. It includes power cable, gas hose, and
switch cord with fitted connections.
1.3.2. Wire Outlet Guide and Feed Roll
Select the proper outlet guide and feed roll from
Table 1.3.
MIG-35, DIGIMIG
using 0.023-in. wire (MT-200)
Feed Roll (U-, V-, or Serrated Groove)
8
25-ft. (7.5m)
---
18232
(See Table 1.3 or
Wire Feeder booklet)
MIG-35
Digimig
17998(V)
2075300(V)
2075303(V)
2075302(V)
2075330(V)
2075299(V)
19761 (Serr.)
19761 (Serr.)
2075261 (Serr.)
2075261 (Serr.)
2075261 (Serr.)
2075257 (Serr.)
2075304 (U)
2075301 (U)