PerkinElmer FL 8500 Installation Instructions Manual page 4

09931488A
M easurem ent
1. Double click on the Spectrum FL software and select the measurement mode.
2. Check the recognition of Accessory.
3. Set up the measurement parameters.
For more detail of method, refer to Spectrum FL Software Users Guide.
NOTE:
4. Click Save to save the method after setting up the parameters.
5. Put the sample into the sample holder. Adjust the proper incident angle by rotating the holder.
6. After setting the angle, fix it with the hand bolt. Close the lid and select the Run icon.
7. Input the sample name and select OK.
8. Confirm the spectrum and results. Save or print the data.
4