Table of Contents
Advertisement
● The mounting slots in the stator segment and rotor segment are dimensioned according
to DIN 508 as listed in the following table. The T-sliding block length depends on the
mounting situation. The T-sliding blocks must be at least as long as the magnetically
active length of the stator segment.
● Use the complete screw-in depth in the T-sliding block. Regularly check the screw
tensioning force. Tighten the fixing screws using a calibrated torque wrench.
● Note the tightening torques specified in the table below.
● Tighten the fixing screws in pairs with angle control.
If you cannot tighten the screws with angle control, then as a minimum use a calibrated
torque wrench with a short wrench insert.
Screw material and tightening torques
Table 5- 1
Stator segment
Rotor segment
*) You can also use screws with a higher property class, taking into account the associated
tightening torques.
Note
Friction value
Underlying friction factor µ
• If necessary, for lower friction values, reduce the tightening torques.
• Please note that the maximum tightening torques of the fixing screws used can be less
than the values listed in the previous table!
1FW68 radial segment motors
Configuration Manual, 04/2017, 6SN1197-0AE02-0BP1
Component
Stator segment
Rotor segment
Required strength classes and tightening torques for the stator and rotor
Component
tot
Screw
(property class) *)
M12 (8.8)
M10 (8.8)
= 0.1
Configuring
5.2 Mounting
acc. to DIN 508
M12 x 18
M10 x 14
Tightening torque
M
in Nm
A
71 Nm
41 Nm
99
Advertisement
Table of Contents
