Siemens SIMOTICS-T 1FW68 Engineering Manual page 104

Configuring
5.2 Mounting
Mounting steps
1. Mount the T-sliding blocks. Do not fully tighten the fixing screws. We recommend a
clearance of between 0.5 mm and a maximum of 1 mm between a T-sliding block and the
inner surface of the fixing profile of the rotor segment.
①
①
②
Figure 5-16
Note
Procedure
The direction when mounting the rotor segments is arbitrary. In the following diagrams,
the direction and the description is from left to right.
Ensure the correct polarity of the rotor segments: When the rotor segments are mounted,
the round N and S marks must be visible, as shown in the diagrams.
Use a calibrated torque wrench to tighten the screws.
104
Clearance between T-sliding block and fixing profile of the rotor segment
Mechanical stop
T-sliding block
T-sliding block
1FW68 radial segment motors
Configuration Manual, 04/2017, 6SN1197-0AE02-0BP1