Table of Contents
Advertisement
EN
3. INSTRUCTIONS FOR INSTALLATION
The electrical connections of the control unit
may only be made by an authorised, professional
electrician and in accordance with the current
regulations. When the installation of the control unit
is complete, the person in charge of the installation
must pass on to the user the instructions for
installation and use that come with the control unit
and must give the user the necessary training for
using the heater and the control unit.
3.1. Installing the Control Panel
Install the control panel outside the sauna room, in
a dry place with an ambient temperature of >0 ºC
where it can be conveniently accessed. Figure 4.
A. Thread the data cable through the hole in
the back cover.
B. Fasten the back cover to a wall with
screws.
C. Push the data cable to the connector.
D. Press the front cover into the
back cover.
A. Provlecte datovy kabel otvorem
v zadnim krytu.
B. Upevnete zadni kryt do steny sauny
C. Pripojte konektor do panelu
D. Zacvaknete predni kryt do
zadni casti ovladaci jednotky
Figure 4.
Fastening the control panel
Obr4.
Pripevneni ovladaci j e dnotky
3.2. Installing the Power Unit
Install the power unit to a wall outside the sauna
room, in a dry place with an ambient temperature
of >0 ºC. See figure 5 for instructions on how to
open the power unit cover and how to fix the unit
to the wall.
Note! Do not embed the control unit into the
wall, since this may cause excessive heating of the
internal components of the unit and lead to damage.
See figure 5.
Figure 5.
Opening the power unit cover and mounting the unit to a wall
Obr 5.
Otevreni POWERBOX U a instalace d steny sauny
Zapojeni ridici jednotky muze byt provedeno pouze
elektrikarem v souladu se soucasnymi
predpisy. Kdyz je instalace ridici jednotky
kompletni,osoba odpovedna za zarizeni
musi predat pokyny pro uzivatele,
instalaci a pouziti, ktere jsou pribaleny
s ridici jednotkou.
a musi uzivatele proskolit ohledne ovladani
kamen a ridici jednotky.
3.1. Instalace ovladaciho panelu
Ovladaci jednotku naistalujte na vnejsi stenu sauny
na suche misto s teplotou vyssi nez 0 C
a s pohodlnym pristupem.
D
B
5 x 40 mm
A
3.2. Instalace POWER BOX U
POWER BOX naistalujte na vnejsi stenu sauny
na suche misto s teplotou vyssi nez 0 C
Podle obr 5 otevrete POVER BOX a upevnete jej na
stenu sauny
Poznamka! Nevkladejte ovladaci jednotku do
steny sauny, protoze to muze zpusobit nadmerne
zahrivani vnitrni casti jednotky a
muze to vest k poskozeni. Viz obr. 5.
3. INSTRUKCE PRO INSTALACI
C
!
!
9
Advertisement
Table of Contents
