Table of Contents
Advertisement
EN
is a problem with lighting or fan. Check the
wiring and functioning of lighting and fan.
3.3. Installing the Temperature Sensor
Wall-mounted heaters (see figure 8)
Fasten the temperature sensor on the wall
•
above the heater, along the vertical centre line
running parallel to the sides of the heater, at a
distance of 100 mm from the ceiling.
Floor-mounted heaters (see figure 9)
Option 1: Fasten the temperature sensor on the
•
wall above the heater, along the vertical centre
line running parallel to the sides of the heater,
at a distance of 100 mm from the ceiling.
Option 2: Fasten the temperature sensor to
•
the ceiling above the heater, at a distance of
200 mm from the vertical centre line of the
heater's side.
With a separate steamer SS20(A), observe that the
temperature sensor must not be installed in the area
affected by steam.
Note! Do not install the temperature sensor closer
than 1000 mm to an omnidirectional air vent or
closer than 500 mm to an air vent directed away
from the sensor. See figure 10. The air flow near an
air vent cools down the sensor, which gives inac-
curate temperature readings to the control unit. As
a result, the heater might overheat.
150 mm
Figure 8.
The place of the temperature and humidity sensors in connection with wall-mounted heaters
Obrazek 8. U m isteni cidel na zed sauny
12
je problem se svetlem nebo ventilatorem.
Zkontrolujte kabely s funkcnost svetla a
ventilatoru.
3.3. Instalace teplotniho cidla
Kamna pripevnena na zed (obr. 8)
Teplotni cidlo pripevnete na zed
v linii kamen - 10 cm od stropu
tak jak vidite na obrazku 8.
Kamna pripevnena na zem (Obr. 9)
A
B
WX232
WX325
Humidity sensor
Vlhkostni cidlo
Permitted area
for WX325
Oblast pro
umisteni cidla
Teplotni cidlo pripevnete na zed
v linii kamen - 10 cm od stropu
tak jak vidite na obrazku 8.
Teplotni cidlo pripevnime
na zed nad kamna, max 20cm od
kraje kamen.
WX232
Temperature sensor
Teplotni cidlo
Advertisement
Table of Contents
