Advertisement
I
Parking paper
If you want to use single sheets, but do not want to
remove the fanfold paper, you can "park" the fanfold
paper.
Tear off the paper at a perforation, so that not more
than half a page protrudes above the paper delivery
selector (if necessary, put the printer in not-ready
mode and feed paper through by pressing the
=
keY until a Perforation iSjust visible above
the paper delivery selector).
Make sure that the printer is in ready mode and
that the release lever is forward. Press the [-]
key. The printer now automatically feeds the paper
backwards until it is no longer in contact with the
platen.
Push the release lever backwards. Now you can load
and print on single sheets.
When you want to resume using fanfold paper, you can
"unpark" it as described in the following section.
Unparking paper
To resume using fanfold paper, you can "unpark" the
fanfold paper as follows:
Remove all single sheets from the printer.
Pull the release lever forward.
Press the [-]
key. The printer feeds the parked
fanfold paper back into position, ready for printing.
Note:
Youcanalwaysunparkpaper, w hether the printeris in "ready
mode"or "not-readymode".
Page 81
Advertisement
