Safety; Symbols Used; Intended Use - Pepperl+Fuchs OPC Manual

OPC / OPD / OPE

Safety

3 Safety
3.1

Symbols Used

This document contains information that you must observe for your own personal
safety and to prevent property damage. Warning messages are shown in
descending order according to the risk level, as follows:
Safety-Relevant Symbols
Danger!
This symbol indicates an imminent danger.
Non-observance will result in personal injury or death.
Warning!
This symbol indicates a possible fault or danger.
Non-observance may cause personal injury or serious property damage.
Caution!
This symbol indicates a possible fault.
Non-observance could interrupt the device and any connected systems and
plants, or result in their complete failure.
3.2

Intended Use

The stationary read devices OPC-*, OPD-*, and OPE-* are used to decode 1-D
and 2-D codes.
The device is only approved for appropriate and intended use. Ignoring these
instructions will void any warranty and absolve the manufacturer from any liability.
Protection of the personnel and the plant is not ensured if the device is not being
used according to its intended use.
7