To dismantle system boards
1 Perform the following procedures:
•
•
•
•
2 The front view of the PCBA board is shown in Figure 8- 10. Turn over
Figure 8-13 Remove the six screws and pull the ribbon cable from the PCBA board
3 Gently disconnect the ribbon cable of the LCD display from the PCBA
4 Unplug the pin connectors at both side of the PCBA board as pointed
5 Gently segregate both the PCBA boards from each other.
• The first PCBA board with LCD display unit attached is the multimeter
• The second PCBA board is the scope measurement board.
Agilent U1602A/U1604A User's and Service Guide
To remove stand
To remove battery pack
To remove handler
To remove front and rear casing
the PCB assembly board with the LCD display facing downward and
remove the screw at the location as pointed in Figure 8- 13.
Pin Connectors
board.
in Figure 8- 13.
measurement board.
General Disassemble
Ribbon Cable
8
193