Agilent Technologies U1602A User's And Service Manual page 26

Figures
26
Figure 4-11 Pressure measurement
Figure 4-12 Set the reading as reference value
Figure 4-13 Set the reading as measured value
Figure 4-14 Relative value obtained from the delta of the measured and
reference value.
Figure 4-15 Automatic measurement in resistance measurement mode
Figure 4-16 Auto-range mode
Figure 4-17 Manual range mode
Figure 5-1 Maximum measurement is selected for resistance data recording.
The initial time base is 15 seconds - 150 seconds.
Figure 5-2 After exceeding 150 seconds, the graph automatically compresses to
half screen and the time base changes to 30 seconds - 300
seconds.
Figure 5-3 Maximum measurement is selected for DC voltage data recording.
The initial time base is 15 seconds - 150 seconds.
Figure 5-4 After exceeding 150 seconds, the graph automatically compresses to
half screen and the time base changes to 30 seconds - 300
seconds.
Figure 7-5 Test connection from calibrator to instrument and digital multimeter
162
Figure 7-6 Test connections from calibrator to instrument
Figure 7-7 Self-calibration dialog box
Figure 8-1 Push towards the arrow direction to remove the stand
Figure 8-2 Disassemble the stand from the instrument
Figure 8-3 Remove battery cover screw
Figure 8-4 Unplug 3-wire connector from PCBA board using tweezer
Figure 8-5 Remove battery pack cover without removing stand
Figure 8-6 Unplug 2-wire connector with a tweezer.
Figure 8-7 Remove screw from the rear cover
Figure 8-8 Remove handler from the instrument
Figure 8-9 Remove and keep the above wear-and-tear parts for re-assemble
process
Figure 8-10 Remove front casing (right) and rear casing (left) from PCBA of the
instrument
137
139
142
142
146
147
176
185
190
191
Agilent U1602A/U1604A User's and Service Guide
138
139
146
147
169
184
184
187
187
189
189
140
186