Table of Contents
Advertisement
User Manual
Ikompact transmitter
Technical description
Ikompact start up
©
Danfoss | February 2019
Use the information below to properly turn the transmitter ON (OPERATION mode).
1. Place the EEPROM and the charged alkaline batteries.
2. Optional: If the transmitter has the STOP button, press and pull it out [1].
[2]
[3]
The status LED [2] will blink blue until the Stand-by mode is reached and then will turn to a constant
blue [3].
3. If the transmitter does not have the STOP button, press the start button.
The status LED will blink green until the transmitter is linked with the receiver.
[1]
RX
BC293071182708en-000101 | 7
Advertisement
Table of Contents
