Safety Instructions; General Safety; Safety Warnings - Danfoss Ikompact User Manual

Transmitter
Hide thumbs Also See for Ikompact:
Table of Contents

Advertisement

User Manual
Ikompact transmitter

Safety instructions

Ikompact general safety
Ikompact safety warnings
4 |
©
Danfoss | February 2019
The following safety instructions must be read carefully in order to install and use the product properly
and to keep it in perfect working condition and to reduce the risk of misuse.
Potential damage to operator and product.
Do not use this product on machines in potentially explosive atmospheres unless the model is ATEX/
RATEX certified to do so.
Strictly adhere to the installation instructions contained in this document.
Make sure that professional and competent personnel carry out the installation.
Ensure that all site and prevailing safety regulations are fully respected.
Make sure that this document is permanently available to the operator and maintenance personnel.
Keep the transmission key when the set is not in use.
On starting each working day, check to make sure that the STOP button and other safety measures
are working.
When in doubt, press the STOP button.
Whenever several sets have been installed, make sure the transmitter is the right one. Identify the
machine controlled on the label for this purpose on the transmitter or by using the display (in case it
has one).
Service the equipment periodically.
When carrying out repairs, only use spare parts from Danfoss.
Potential damage to operator and product.
Follow the guidelines below to reduce risk of injury to the operator and the product.
Use the device with the manufacturer's battery and battery charger (if applicable).
Only allow qualified personnel to operate the equipment.
Always set the STOP button in the off position when not in use.
Always press STOP before plugging in tether cable (if applicable).
Do not operate product when visibility is limited.
Make sure product is compatible with the machine.
Avoid knocking or dropping the product.
Do not use the product if a failure is detected.
Changes or modifications not approved by Danfoss can void the user's authority to operate this product.
BC293071182708en-000101

Advertisement

Table of Contents
loading

Table of Contents