Verify Initial Connection - Digi AnywhereUSB Plus Series User Manual

Get started

Verify initial connection

After the hardware has been connected and powered on, and you have installed the AnywhereUSB
Manager, verify that the Hub connection is working as expected. You will need a USB flash drive to
follow the verification process below.
1. Verify that your Hub powered on. The power LED is solid blue.
2. Plug your USB flash drive into port 1 on the Hub.
3. Verify that the USB port 1 LED is solid yellow, green, or blue, depending on whether the USB
flash drive is 1.1, 2.0, or 3.1.
4. If not already open,
5. Expand AnywhereUSB® Plus Hubs to display a list of AnywhereUSB® Plus Hubs.
6. Verify that the serial number of the Hub is in the list. You can find the serial number on the
Hub's label.
7. You will notice that the Manager is showing the Hub in an error state, with a red X appearing
next to the Hub name. Click on the Hub to update information in the Hub Status pane. The
Hub State appears as "Unregistered Client ID."
This is a security feature. The Hub administrator needs
the client ID to the client list.
AnywhereUSB® Plus User Guide
launch the AnywhereUSB Manager.
to allow each new client ID
Verify initial connection
by adding
23