Set Cloud - Digi AnywhereUSB Plus Series User Manual

Configure the AnywhereUSB Plus Hub from the CLI
set cloud
Purpose
Enables you to enable and configure the Hub's access to Remote Manager.
Note This command performs the same functions as the options in the
Configuration page in the web
Syntax
set cloud [ options ]
Options
server=[server address text]
Enter the name of your Remote Manager server.
enable=[on|off]
Enables or disables Remote Manager.
reconnect=[none|(10-3600 seconds)]
Specify the amount of time to wait after the Hub has been disconnected from Remote Manager
before the Hub should automatically try to reconnect. The time is measured in seconds.
rxkeepalive=[5-7200 seconds]
Specify the interval at which the Hub sends a keep-alive packet to Remote Manager if the Remote
Manager connection is idle. Remote Manager expects to receive either Remote Manager protocol
messages or keep-alive packets at the specified interval. The time is measured in seconds.
txkeepalive=[5-7200 seconds]
Specify the interval at which the Remote Manager-registered Hub sends a keep-alive packet to
Remote Manager if the Remote Manager connection is idle. The Hub expects to receive either Remote
Manager protocol messages or keep-alive packets at the specified interval. The time is measured in
seconds.
waitcount=[2-64]
Specify the number of consecutive keep-alives can be missed before the connection between Remote
Manager and the Hub is considered lost and subsequently closed by the Hub and Remote manager.
AnywhereUSB® Plus User Guide
UI.
set cloud
Remote Manager
139